User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 298 System Manual
4.3.10.12.4 Terminating a Service Interface Configuration Mode
This section describes the commands for:
 “Terminating the IP-IP Service Interface Configuration Mode”
 “Terminating the VLAN Service Interface Configuration Mode”
 “Terminating the QinQ Service Interface Configuration Mode”
4.3.10.12.4.1 Terminating the IP-IP Service Interface Configuration Mode
Run the following command to terminate the IP-IP service interface configuration
mode:
npu(config-srvcif-ipip)# exit
4.3.10.12.4.2 Terminating the VLAN Service Interface Configuration Mode
Run the following command to terminate the vlan service interface configuration
mode:
npu(config-srvcif-vlan)# exit
Command
Syntax
npu(config-srvcif-ipip)# exit
Privilege
Level
10
Command
Modes
IP-IP Service interface configuration mode
Command
Syntax
npu(config-srvcif-vlan)# exit
Privilege
Level
10
Command
Modes
VLAN Service interface configuration mode