User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 305 System Manual
4.3.10.13.1.3 Restoring the Default Configuration Parameters for the Authentication Port
Run the following command to restore the default configuration for the
authentication port.
npu(config-aaa)# no [primary-serveraddr] [alternate-serveraddr]
[auth-port] [acct-port <port>]
When you execute this command for restoring the default values, it also deletes
the current values for the primary-server and alternate-server address.
4.3.10.13.1.4 Terminating the AAA Client Configuration Mode
Run the following command to terminate the AAA client configuration mode:
npu(config-aaa)# exit
[acct-port
<port>]
Denotes the accounting port
on which the AAA client
listens to and sends RADIUS
accounting messages.
Optional 1813 0-65535
Command
Modes
AAA client configuration mode
NOTE
Refer to Section 4.3.10.2.1 for a description and default values of these parameters.
Command
Syntax
npu(config-aaa)# no
[primary-serveraddr] [alternate-serveraddr]
[auth-port] [acct-port <port>]
Privilege
Level
10
Command
Modes
AAA client configuration mode
Command
Syntax
npu(config-aaa)# exit
Privilege
Level
10