User Manual

Chapter 4 - Operation and Administration Using the CLI Using the Command Line Interface for 4Motion System

4Motion 117 System Manual

npu(config-if)# shutdown

c Run the following command to assign an IP address to this interface:

npu(config-if)# ip address <ip-address> <subnet-mask>

d Run the following command to enable this interface:

npu(config-if)# no shutdown

2 Connect the Ethernet cable to the DATA connector on the front panel of the

NPU. (Refer Table 4-8 for more information about the Ethernet port to be used

for the connectivity mode you have selected).

3 To enable exchange of packets, create IP-level connectivity between the remote

machine and the external-management interface.

4 From the remote terminal, execute the following command to use Telnet/SSH

to access the IP address of the external-management interface:

telnet <ip address of external-management interface>

ssh <ip address of external-management interface>

5 At the prompt, enter your login ID and password.

After you provide your login information, the following command prompt is

displayed:

npu#

This is the global command mode. For more information about different command

modes, refer to Section 4.1.2.

4.1.2 Command Modes

The CLI provides a number of command modes, some of which are listed in the

following table for executing different types of commands:

NOTE

The default login ID and password are:

Password: admin123