User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 308 System Manual
 “Displaying Global RADIUS Configuration Parameters” on page 310
4.3.10.13.2.1 Configuring Global RADIUS Parameters
To configure the global RADIUS configuration parameters to be used for all AAA
clients, run the following command:
npu(config)# radius <[accessreq-retries <retransmissions>]
[accessreq-interval <timeout>] [nasid <nas-identifier>]
[timezone-offset <time-offset(0-86400)>] [mtu <framed mtu
size(1020-2000)>][RadiusAtrbtTypeServiceProfileName
<AtrbtTypeId(1-255)>]>
NOTE
You can display configuration information for global RADIUS parameters. For details, refer to
Section 4.3.10.13.2.3
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
Command
Syntax
npu(config)# radius <[accessreq-retries <retransmissions>]
[accessreq-interval <timeout>] [nasid <nas-identifier>] [timezone-offset
<time-offset(0-86400)>] [mtu <framed mtu size(1020-2000)>]
[RadiusAtrbtTypeServiceProfileName <AtrbtTypeId(1-255)>]>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[accessreq-ret
ries
<retransmissio
ns>]
Denotes the maximum
number of times the AAA
client can resend the access
request.
Optional 3 0-5
[accessreq-int
erval
<timeout>]
Denotes the interval, in
seconds, after which the AAA
client can resend the access
request.
Optional 500 10-100000