User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 313 System Manual
4.3.10.14.2 Configuring Common Parameters of a Service Group
After enabling the service group configuration mode, run the following command
to configure common parameters for the service group:
npu(config-srvcgrp)# config {{[srvcif-alias <service interface>]
[waitdhcp-holdtime <timeout>] [dhcp-ownaddr <ipv4addr>]} |
{dhcp-server|dhcp-proxy|dhcp-relay} |{[<ServiceGrpIfAccounting
(enable|disable)>]}|{[<ServiceGrpIfMSLoopBack (enable|disable)>]}}
This commands comprises 4 sub-commands:
1 npu(config-srvcgrp)# config {[srvcif-alias <service interface>]
[waitdhcp-holdtime <timeout>] [dhcp-ownaddr <ipv4addr>]}
2 npu(config-srvcgrp)# config {dhcp-server|dhcp-proxy|dhcp-relay}
3 npu(config-srvcgrp)# config {[<ServiceGrpIfAccounting (enable|disable)>]}
4 npu(config-srvcgrp)# config {[<ServiceGrpIfMSLoopBack (enable|disable)>]}
Command
Modes
Global configuration mode
NOTE
This command is applicable for an IP Service Group. In VPWS-QinQ and
VPWS-Transparent Service Groups only the accounting option
(ServiceGrpIfAccounting (enable|disable)) is available.
NOTE
You can display configuration information for the service group. For details, refer to
Section 4.3.10.15.2.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
Command
Syntax
npu(config-srvcgrp)# config {{[srvcif-alias <service interface>]
[waitdhcp-holdtime <timeout>] [dhcp-ownaddr <ipv4addr>]} |
{dhcp-server|dhcp-proxy|dhcp-relay} |{[<ServiceGrpIfAccounting
(enable|disable)>]}|{[<ServiceGrpIfMSLoopBack (enable|disable)>]}}