User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 317 System Manual
4.3.10.14.4.2 Configuring the DHCP Server
After enabling the service group operation mode for the DHCP server, you can
execute any of the following tasks:
 “Configuring DHCP Server Parameters” on page 318
 “Restoring Configuration Parameters for the DHCP Server” on page 320
 “Configuring Exclude IP Addresses for the DHCP Server” on page 321
 “Deleting Exclude IP Addresses for the DHCP Server” on page 322
NOTE
You cannot modify the configured DHCP mode. To change the DHCP mode you should first delete
the Service Group and configure it again.
Command
Syntax
npu(config-srvcgrp)# config {dhcp-server|dhcp-proxy|dhcp-relay}
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
{dhcp-server|d
hcp-proxy|dhcp
-relay}
Indicates whether the service
group operation mode is to be
enabled for the DHCP server,
proxy or relay.
Mandatory N/A
 dhcp-server
 dhcp-proxy
 dhcp-relay
Command
Modes
Service group configuration mode
NOTE
Before executing these tasks, ensure that you have enabled the DHCP server configuration mode.
For details, refer to
“Enabling the Service Group Operation Mode for DHCP
Server//Proxy/Relay” on page 316
.