User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 318 System Manual
4.3.10.14.4.2.1Configuring DHCP Server Parameters
Run the following command to configure the DHCP server:
npu(config-srvcgrp-dhcpserver)# config ([pool-minaddr <string>]
[pool-maxaddr <string>] [pool-subnet <string>] [dflt-gwaddr
<string>] [lease-interval <integer(24-2147483647)>]
[renew-interval <integer>] [rebind-interval <integer>]
[dnssrvr-addr <string>] [offerreuse-holdtime <integer>] [opt60
<string(30)>] [opt43 {[Name <string(64)>] [Value <string(64)>]}]
[Sname <string(64)>] [File <string(128)>])
NOTE
If DHCP IP pool (pool-minaddr and/or pool-maxaddr) need to be changed, the service group should
be deleted and reconfigured with the new DHCP IP pool.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
Command
Syntax
npu(config-srvcgrp-dhcpserver)# config ([pool-minaddr <string>]
[pool-maxaddr <string>] [pool-subnet <string>] [dflt-gwaddr
<string>] [lease-interval <integer(24-2147483647)>]
[renew-interval <integer>] [rebind-interval <integer>]
[dnssrvr-addr <string>] [offerreuse-holdtime <integer>] [opt60
<string(30)>] [opt43 {[Name <string(64)>] [Value <string(64)>]}]
[Sname <string(64)>] [File <string(128)>])
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[pool-minadd
r <string>]
Denotes the minimum
(lowest) IP address of the
address pool to be used for
address allocation for MSs
from this Service Group.
Optional 0.0.0.0 Valid IP
Address