User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 328 System Manual
4.3.10.14.4.4 Configuring the DHCP Relay
After enabling the service group operation mode for the DHCP relay, you can
execute any of the following tasks:
 “Configuring the DHCP Relay Parameters” on page 328
 “Terminating the DHCP Relay Configuration Mode” on page 332
4.3.10.14.4.4.1Configuring the DHCP Relay Parameters
Run the following command to configure the DHCP server address for the DHCP
relay:
npu(config-srvcgrp-dhcprelay)# config ([server-addr <ipV4Addr>]
[{EnableOpt82|DisableOpt82}])
Command
Modes
Service group-DHCP proxy configuration mode
IMPORTANT
An error may occur if you provide an invalid value for the DHCP server address. Refer the syntax
description for more information about the appropriate values and format for configuring this
parameters.
Command
Syntax
npu(config-srvcgrp-dhcprelay)# config ([server-addr <ipV4Addr>]
[{EnableOpt82|DisableOpt82}])
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[server-addr
<ipv4addr>]
Denotes the IP address of the
external DHCP server,
Mandatory N/A Valid IP
Address
[{EnableOpt8
2|DisableOpt
82}]
Denotes whether DHCP
option 82 is enabled or
disabled.
Optional Disable
Opt82
 EnableOpt82
 DisableOpt8
2