User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration

4Motion 329 System Manual

4.3.10.14.4.4.2Configuring the DHCP Relay Option 82 Parameters

If Option 82 for the DHCP Relay is enabled, run the following command to

configure suboptions of option 82 of DHCP messages:

npu(config-srvcgrp-dhcprelay-Opt82)# config ([Subopt1value

{Default|MSID|BSID|NASID|NASIP|Full-NAI|Domain|AsciiFrStrng

<string(32)>|BinFrStrng <string(32)>}] [Subopt2value

{Default|MSID|BSID|NASID|NASIP|Full-NAI|Domain|AsciiFrStrng

<string(32)>|BinFrStrng <string(32)>}] [Subopt6value

{Default|MSID|BSID|NASID|NASIP|Full-NAI|Domain|AsciiFrStrng

<string(32)>|BinFrStrng <string(32)>}] [{Subopt7value [service-type]

[vendor-specific] [session-timeout]}] [{EnableUnicast|DisableUnicast}])

Command

Modes

Service group-DHCP relay configuration mode

IMPORTANT



For DhcpRlOpt82SubOpt1BinFrstrng value, enter hex string without spaces.

 If Opt82Unicast is enabled then DHCP relay agent appends option 82 to all DHCP messages

(unicast and broadcast).

 If Opt82Unicast is disabled (default) then DHCP relay agent appends option 82 only to

broadcast DHCP request messages.

Command

Syntax

npu(config-srvcgrp-dhcprelay-Opt82)# config ([Subopt1value

{Default|MSID|BSID|NASID|NASIP|Full-NAI|Domain|AsciiFrStrng

<string(32)>|BinFrStrng <string(32)>}] [Subopt2value

{Default|MSID|BSID|NASID|NASIP|Full-NAI|Domain|AsciiFrStrng

<string(32)>|BinFrStrng <string(32)>}] [Subopt6value

{Default|MSID|BSID|NASID|NASIP|Full-NAI|Domain|AsciiFrStrng

<string(32)>|BinFrStrng <string(32)>}] [{Subopt7value [service-type]

[vendor-specific] [session-timeout]}] [{EnableUnicast|DisableUnicast}])

Privilege

Level