User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 337 System Manual
1 Enable the service profile configuration mode (refer to Section 4.3.10.15.3.1)
2 You can now execute any of the following tasks:
» Configure the parameters for this service profile (refer to
Section 4.3.10.15.3.2)
» Manage service flow configuration for this service profile (refer to
Section 4.3.10.15.3.3)
» Delete service flows (refer to Section 4.3.10.15.3.3.7)
3 Terminate the service profile configuration mode (refer to
Section 4.3.10.15.3.4)
You can, at any time, display configuration information (refer to
Section 4.3.10.15.3.5) or delete an existing service profile (refer to
Section 4.3.10.15.3.6).
4.3.10.15.3.1 Enabling the Service Profile Configuration Mode\Creating a New Service
Profile
To configure the parameters for a service profile, first enable the service profile
configuration mode. Run the following command to enable the service profile
configuration mode. You can also use this command to create a new service
profile.
npu(config)# srvc-profile <profile-name>
If you use this command to create a new service profile, the configuration mode
for this rule is automatically enabled, after which you can execute any of the
following tasks:
 Configure the parameters for this service profile (refer to Section 4.3.10.15.3.2)
 Manage service flow configuration for this service profile (refer to
Section 4.3.10.15.3.3)
 Delete service flows (refer to Section 4.3.10.15.3.3.7)
After you have executed these tasks, terminate the service profile configuration
mode (refer to Section 4.3.10.15.3.4) to return to the service group configuration
mode.
To configure one or more service profiles: