User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 338 System Manual
4.3.10.15.3.2 Enabling/Disabling the Service Profile
After enabling the service profile configuration mode, run the following command
to enable this service profile:
npu(config-srvcprfl)# config profile-enable
A service profile can be enabled only if at least one service flow is configured.
To disable this service profile, run the following command:
npu(config-srvcprfl)# no profile-enable
The default mode is Disabled.
Command
Syntax
npu(config)# srvc-profile <profile-name>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<profile-name> Denotes the name of the
service profile for which the
configuration mode is to be
enabled.
If you are creating a new
service profile, specify the
name of the new service
profile. The configuration
mode is automatically
enabled for the new service
profile.
Mandatory N/A String (1 to 11
characters)
Command
Modes
Global configuration mode
NOTE
You can display configuration information for specific or all service profiles. For details, refer to
Section 4.3.10.15.3.5.