User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration

4Motion 340 System Manual

4.3.10.15.3.3.1Enabling the Service Flow Configuration Mode\ Creating a New Service

Flow

To configure the parameters for a service flow, first enable the service flow

configuration mode. Run the following command to enable the service flow

configuration mode. You can also use this command to create a new service flow.

npu(config-srvcprfl)# flow [<flow-id (1-255)] [ServiceGrpAlias

<srvc-grp-alias>] [ServiceIfAlias <string>]

If you use this command to create a new service flow, the configuration mode for

this service flow is automatically enabled, after which you can execute any of the

following tasks:

 Configure the parameters for this service flow (refer to Section 4.3.10.15.3.3.2)

 Restore the default parameters for this service flow (refer to

Section 4.3.10.15.3.3.3)

 Configure uplink/downlink classification rule names (refer to

Section 4.3.10.15.3.3.4)

After you have executed these tasks, you can terminate the service flow

configuration mode, and return to the service profile configuration mode (refer to

Section 4.3.10.15.3.3.6).

Command

Syntax

npu(config-srvcprfl)#flow [<flow-id (1-255)] [ServiceGrpAlias

<srvc-grp-alias>] [

ServiceIfAlias <string>]

Privilege

Level