User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 347 System Manual
4.3.10.15.3.3.3Restoring the Default Service Flow Configuration Parameters
Run the following command to restore the default values of one or several
parameters for this service flow:
npu(config-srvcprfl-flow)# no [cs-type] [media-type]
[uldatadlvry-type] [ulqos-maxsustainedrate]
[ulqos-trafficpriority] [dldatadlvry-type]
[dlqos-maxsustainedrate]
[dlqos-trafficpriority][ulSfQosMinReservedRate]
[ulSfQosMaxLatency] [ulSfQosToleratedJitter]
[ulSfQosUnsolicitedGrantInterval] [ulSfQosSduSize]
[dlSfQosMinReservedRate] [dlSfQosMaxLatency]
[dlSfQosToleratedJitter] [dlSfQosSduSize]
Do not specify ant parameter to restore all parameters to their
default values.
Command
Modes
Service profile-service flow configuration mode
NOTE
Refer to Section 4.3.10.15.3.3.2 for a description and default values of these parameters.
Command
Syntax
npu(config-srvcprfl-flow)#
no [cs-type] [media-type]
[uldatadlvry-type] [ulqos-maxsustainedrate]
[ulqos-trafficpriority] [dldatadlvry-type]
[dlqos-maxsustainedrate]
[dlqos-trafficpriority][ulSfQosMinReservedRate]
[ulSfQosMaxLatency] [ulSfQosToleratedJitter]
[ulSfQosUnsolicitedGrantInterval] [ulSfQosSduSize]
[dlSfQosMinReservedRate] [dlSfQosMaxLatency]
[dlSfQosToleratedJitter] [dlSfQosSduSize]
Privilege
Level
10
Command
Modes
Service profile-service flow configuration mode