User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 351 System Manual
4.3.10.15.3.3.7Deleting Service Flows
You can, at any time, run the following command to delete one or all service flows:
npu(config-srvcprfl)# no flow [<flow-id>]
4.3.10.15.3.4 Terminating the Service Profile Configuration Mode
Run the following command to terminate the service profile configuration mode:
Privilege
Level
10
Command
Modes
Service profile-service flow configuration mode
CAUTION
Specify the flow ID if you want to delete a specific service flow. Otherwise all the configured service
flows are deleted.
Command
Syntax
npu(config-srvcprfl)# no flow [<flow-id>]
Privilege
Level
10
Command
Syntax
npu(config-srvcprfl)# no flow [<flow-id>]
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[<flow-id>] Denotes the flow ID of the
service flow to be deleted.
If you do nort specify a value
for this parameter, all the
service flows are deleted.
Optional N/A 0-2
32
Command
Modes
Service profile configuration mode