User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 357 System Manual
2 You can now execute any of the following tasks:
» Configure the parameters for this classification rule (refer to
Section 4.3.10.15.4.2)
» Restore the default parameters for this classification rule (refer to
Section 4.3.10.15.4.3)
» Manage protocol configuration (refer to Section 4.3.10.15.4.4)
» Manage source address configuration (seeSection 4.3.10.15.4.5)
» Manage destination address configuration (refer to Section 4.3.10.15.4.6)
» Manage source port configuration (refer to Section 4.3.10.15.4.7)
» Manage destination port configuration (refer to Section 4.3.10.15.4.8)
3 Terminate the L3 classification rules configuration mode (refer to
Section 4.3.10.15.4.9)
You can, at any time, display configuration information (refer to
Section 4.3.10.15.4.13) or delete an existing classification rule (refer to
Section 4.3.10.15.4.14), protocol lists (refer to Section 4.3.10.15.4.4.5), source
addresses (refer to Section 4.3.10.15.4.5.5), destination addresses (refer to
Section 4.3.10.15.4.6.5), source ports (refer to Section 4.3.10.15.4.7.5), or
destination ports (refer to Section 4.3.10.15.4.8.5) configured for this
classification rule.
1 Enable the L2 classification rules configuration mode (refer to
Section 4.3.10.15.4.1)
2 You can now execute any of the following tasks:
» Configure the parameters for this classification rule (refer to
Section 4.3.10.15.4.10)
» Clear the configuration of this classification rule (refer to
Section 4.3.10.15.4.11)
» Terminate the L2 classification rules configuration mode (refer to
Section 4.3.10.15.4.12)
To configure one or more L2 classification rules: