User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 359 System Manual
 Clear the current configuration of this classification rule (refer to
Section 4.3.10.15.4.11)
After you have executed these tasks, you can terminate the classification rules
configuration mode (refer to Section 4.3.10.15.4.12).
4.3.10.15.4.2 Specifying Configuration Parameters for the L3 Classification Rule
After enabling the classification rules configuration mode for an L3 classification
rule, run the following command to configure the parameters for this
classification rule:
npu(config-clsfrule)# config [priority <priority(0-255)>]
[phs-rulename <rulename>] [iptos-low <value(0-63)>] [iptos-high
<value(0-63)>] [iptos-mask <value(0-63)>] [iptos-enable]
Command
Syntax
npu(config)# clsf-rule <rulename> [clsfRuleType {L2 | L3}]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<rulename> Denotes the name of the
classification rule.
Mandatory N/A String (1 to 11
characters)
[clsfRuleTyp
e {L2 | L3}]
The type of classifier: L2 or
L3.
Optional
when
creating a
new rule.
L3
 L2
 L3
Command
Modes
Global configuration mode
NOTE
You can display configuration information for specific or all classification rules. For details, refer to
Section 4.3.10.15.4.13.