User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 361 System Manual
4.3.10.15.4.3 Restoring the Default Parameters for the L3 Classification Rule
Run the following command to restore the default configuration for this
classification rule.
npu(config-clsfrule)# no [priority] [iptos-low] [iptos-high]
[iptos-mask] [iptos-enable][phs-rulename]
4.3.10.15.4.4 Managing Protocol Configuration for the L3 Classification Rule
L3 classification rules can classify the packet, based on the value of IP protocol
field. You can configure the value of IP protocol for a given classification rule.
1 Enable the IP protocol configuration mode (refer to Section 4.3.10.15.4.4.1)
[iptos-enable] Indicates whether the use of
TOS-based classification is to
be enabled.
Optional By
default,
the use
of
TOS-bas
ed
classifica
tion is
disabled.
The
presence/abse
nce of this flag
indicates that
the use of
TOS-based
classification
should be
enabled/disabl
ed.
Command
Modes
L3 Classification rules configuration mode
NOTE
Refer to Section 4.3.10.15.4.3 for a description and default values of these parameters.
Command
Syntax
npu(config-clsfrule)# no
[priority] [iptos-low] [iptos-high]
[iptos-mask] [iptos-enable] [phs-rulename]
Privilege
Level
10
Command
Modes
L3 Classification rules configuration mode
To configure one or more IP protocols: