User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 365 System Manual
4.3.10.15.4.5 Managing Source Address Configuration for the L3 Classification Rule
Classification rules can classify the packet, based on the source address of the
packet. You can configure the value of source address for a given classification
rule.
1 Enable the source address configuration mode (refer to
Section 4.3.10.15.4.5.1)
2 You can now execute any of the following tasks:
» Configure the address mask (refer to Section 4.3.10.15.4.5.2)
» Disable the source address (refer to Section 4.3.10.15.4.5.3)
3 Terminate the source address configuration mode (refer to
Section 4.3.10.15.4.5.4)
You can, at any time, delete an existing source address (refer to
Section 4.3.10.15.4.5.5).
The following example illustrates the (sequence of) commands for enabling the
source address configuration mode, configuring the address mask, and then
terminating the source address configuration mode:
npu(config-clsfrule)# srcaddr 10.203.155.20
npu(config-clsfrule-srcaddr)# config addr-enable addr-mask
255.255.0.0
npu(config-clsfrule-srcaddr)# exit
Command
Syntax
npu(config-clsfrule)# no ip-protocol
Privilege
Level
10
Command
Modes
L3 Classfication rule-IP protocol configuration mode
To configure one or more source addresses: