User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 367 System Manual
4.3.10.15.4.5.2Configuring the Address Mask
After enabling the source address configuration mode, run the following command
to configure the address mask for the source address.
npu(config-clsfrule-srcaddr)# config [addr-enable] [addr-mask
<value>]
You can also run this command to enable a source address that is currently
disabled. For details, refer to “Disabling the Source Address” on page 368.
Command
Modes
L3 Classification rules configuration mode
IMPORTANT
An error may occur if you provide an invalid address mask for the source address. Refer the syntax
description for more information about the appropriate value and format for this parameter.
Command
Syntax
npu(config-clsfrule-srcaddr)# config [addr-enable] [addr-mask <value>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default Value Possible
Values
[addr-enable] Indiactes that the use of
the associated source
address is enabled for
the classification rule
that you are configuring.
If the use of this address
is disabled, the
associated source
address is ignored while
classifying the packet.
Optional By default, the
use of the
associated
source address
is disabled.
The
presence/abse
nce of this flag
indicates that
the use of the
associated
source address
is
enabled/disabl
ed.
[addr-mask
<value>]
Denotes the mask field
that is used to specify a
range of source
addresses.
Optional 255.255.255.25
5
Valid address
mask