User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 369 System Manual
4.3.10.15.4.5.5Deleting Source Addresses
You can, at any time, run the following command to delete one or all source
addresses
npu(config-clsfrule)# no srcaddr [<ipv4addr>]
CAUTION
Specify the IP address if you want to delete a specific source address. Otherwise all the configured
source addresses are deleted.
IMPORTANT
An error may occur if you provide an invalid IP address. Refer the syntax description for more
information about the appropriate values and format for configuring this parameter.
Command
Syntax
npu(config-clsfrule)# no srcaddr [<ipv4addr>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[<ipv4addr>] Denotes the IPv4 address of
the source address that you
want to delete from a
classification rule.
Specify this parameter only if
you want to delete a specific
source address. If you do not
specify a value for this
parameter, all the configured
source addresses of the
classification rule will be
deleted.
Optional N/A Valid IP
Address
Command
Modes
L3 Classification rules configuration mode