User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 377 System Manual
4.3.10.15.4.7.4Terminating the Source Port Configuration Mode
Run the following command to terminate the source port configuration mode:
npu(config-clsfrule-srcport)# exit
4.3.10.15.4.7.5Deleting Source Ports
Run the following command to delete one or all source ports
npu(config-clsfrule)# no srcport [<start-port> <end-port>]
Command
Modes
L3 Classification rules-source port configuration mode
Command
Syntax
npu(config-clsfrule-srcport)# exit
Privilege
Level
10
Command
Modes
L3 Classfication rule-source port configuration mode
CAUTION
Specify the start and end port numbers if you want to delete a specific souce port. Otherwise all the
configured source ports are deleted.
IMPORTANT
An error may occur if you provide an invalid value for the start-port and end-port parameters.
Refer the syntax description for more information about the appropriate values and format for
configuring these parameters.
Command
Syntax
npu(config-clsfrule)# no srcport [<start-port> <end-port>]
Privilege
Level
10