User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 382 System Manual
4.3.10.15.4.9 Terminating the L3 Classification Rule Configuration Mode
Run the following command to terminate the L3 classification rules configuration
mode:
npu(config-clsfrule)# exit
4.3.10.15.4.10Specifying Configuration Parameters for the L2 Classification Rule
After enabling the classification rules configuration mode for an L2 classification
rule, run the following command to configure the parameters for this
classification rule:
npu(config-clsfrule-L2)# cvid <value(1-4094)>
Command
Modes
L3 Classification rules configuration mode
Command
Syntax
npu(config-clsfrule)# exit
Command
Modes
L3 Classification rules configuration mode
NOTE
You can display configuration information for specific or all classification rules. For details, refer to
Section 4.3.10.15.4.13.
Command
Syntax
npu(config-clsfrule-L2)# cvid <value(1-4094)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
cvid
<value(1-4094)
>
Denotes the Customer VLAN
ID value to be assigned to the
classification rule.
Mandatory N/A 1-4094