User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 387 System Manual
npu(config-phsrule)# config field
000000000000000000000000FFFFFFFF00000000 mask 000F00 verify 0 size
20
npu(config-phsrule)# exit
4.3.10.16.1 Enabling the PHS Rules Configuration Mode /Creating a New PHS Rule
To configure the parameters for a PHS rule, first enable the PHS rules
configuration mode. Run the following command to enable the PHS rules
configuration mode. You can also use this command to create a new PHS rule.
npu(config)# phs-rule <rulename>
If you use this command to create a new PHS rule, the configuration mode for this
PHS rule is automatically enabled, after which you can configure the parameters
for the PHS rule (refer to Section 4.3.10.16.2). You can then terminate the PHS
rules configuration mode (refer to Section 4.3.10.16.3) and return to the global
configuration mode.
4.3.10.16.2 Configuring Parameters for the PHS Rule
Run the following command to configure the parameters of the PHS rule:
npu(config-phsrule)# config <[field <value>] [mask <value>] [verify
<value>] [size <value>]>
Command
Syntax
npu(config)# phs-rule <rulename>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<rulename> Denotes the PHS rule for
which the PHS configuration
mode is to be enabled.
Mandatory N/A String (1 to 11
characters)
Command
Modes
Global configuration mode