User Manual

Chapter 4 - Operation and Administration Using the CLI Using the Command Line Interface for 4Motion System
4Motion 126 System Manual
4.1.5.2 Managing Privileges
To enable users to execute commands that require a higher privilege level (than
their currently configured default level), you can configure a password for each
privilege level. Other users can then use the password you have specified to
enable a higher privilege level.
This section describes the commands for:
 “Assigning a Password for a Privilege Level” on page 126
 “Deleting a Password for a Privilege Level” on page 127
4.1.5.2.1 Assigning a Password for a Privilege Level
To assign a password for a privilege level, run the following command:
npu(config)# enable password [Level <0-15>] <password>
IMPORTANT
Only users who have logged in as root can assign or delete passwords for any privilege level.
IMPORTANT
Only users who have logged in as root can execute this command.
IMPORTANT
After you execute this command, any user can use this password to enable the (higher) privilege
level for which you have configured the password. For more information about using passwords for
enabling higher privilege levels, refer Section 4.1.5.3.
IMPORTANT
An error may occur if:
 You are trying to configure a password for a privilege level that is higher than your default
privilege level.
 The password that you have specified is more than 20 characters.
 The privilege level that you have specified is not within the range, 0-15.
Command
Syntax
npu(config)# enable password [Level <0-15>] <password>