User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 406 System Manual
4.3.11.1.7 Displaying Log Files Residing on the NPU Flash
You can display a list of log files that are residing on the NPU flash. For details,
refer Section 4.10.4.
4.3.11.2 Configuring Module-level Logging
You can configure logging (enable/disable) separately for the following modules,
and define the severity level for which logging is required:
 System startup procedures
 NPU/AU upgrade procedures
 Fault management procedures
 System performance procedures
 Shelf management procedures
 WiMAX signaling protocols
 User interface
 AU management procedures
This section describes the commands to be used for:
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[<file name>] Indicates the name of the
compressed log file to be
deleted. If you do not specify
the file name, all the log files
residing in the NPU flash are
deleted.
Always suffix the file name
with .gz.
Optional N/A <file name>.gz
Command
Modes
Global configuration mode