User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration

4Motion 408 System Manual

Specify the module name if you want to configure the severity level separately for

this module. If you do not specify the name of the module, the severity level that

you configure in this command is applied to all modules.

For example, run the following command if you want logs to be created for WiMAX

signaling protocols when the severity level is Warning or higher:

npu(config)# log level SIGASN WARN

Or run the following command to set the severity level to Error for all modules:

npu(config)# log level ERROR

Table 4-21: Modules for which Logging can be Enabled

Parameter Refers to...

StartupMgr System startup procedures

SWDownload Software upgrade procedures

FaultMgr Fault management procedures

ShelfMgr Shelf management procedures

SIGASN WiMAX signaling protocols

UserIF User-initiated procedures

AUMgr Internal processes used for managing AU

PerfMgr Performance management procedures

NOTE

You can display the currently configured severity levels for each module. For details, refer

Section 4.3.11.2.2.

Command

Syntax

npu(config)# log level

[{StartupMgr|SWDownload|FaultMgr|PerfMgr|ShelfMgr|SIGASN|UserIF|AUMgr}]

{EMERG|ALERT|CRIT|ERROR|WARN|NOTICE|INFO}

Privilege

Level