User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 424 System Manual
4.3.13.1.3 Displaying Configuration Information for SNMP Managers
To display configuration information for all SNMP Managers, run the following
command:
npu# show snmp-mgr
4.3.13.2 Configuring the Trap Manager
The SNMP Agent can send traps to multiple Trap Managers, for which an entry
exists in the 4Motion system. After you have created an entry for a Trap Manager,
you are required to enable the Trap Manager. You can, at any time, disable a Trap
Manager for the 4Motion system.
This section describes the commands for:
 “Adding/Modifying a Trap Manager entry” on page 425
 “Deleting an Entry for the Trap Manager” on page 426
 “Enabling/Disabling the Trap Manager” on page 427
Command
Modes
Global configuration mode
IMPORTANT
An error may occur if there is no existing SMNP Manager entry.
Command
Syntax
npu# show snmp-mgr
Privilege
Level
1
Display
Format
Snmp Manager Table
--------------------------------
Manager Index:(1) Read Only Community:(<value>) Read WriteCommunity:
(<value>)
Command
Modes
Global command mode