User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 425 System Manual
 “Displaying Configuration Information for Trap Managers” on page 427
 “Displaying the Trap Rate Limit” on page 428
4.3.13.2.1 Adding/Modifying a Trap Manager entry
You can configure up to five Trap Manager entries for the 4Motion system. To add
a Trap Manager entry, or to modify an existing entry, run the following command:
npu(config)# trap-mgr ip-source <ip_addr> [Port <(0-65535)>]
[TrapCommunity <string>] [EnableFlag <integer(1 for enable, 2 for
disable)>]
You can view configuration information for existing Trap Managers. For details,
refer Section 4.3.13.2.4.
IMPORTANT
An error may occur if :
 You have specified invalid values for the IP address, Trap Community or port.
 The IP address is already configured for another Trap Manager.
 You are trying to create more than five Trap Managers. (You can configure up to five Trap
Managers for the 4Motion system.
Command
Syntax
npu(config)# trap-mgr ip-source <ip_addr> [Port <(0-65535)>]
[TrapCommunity <string>] [EnableFlag <integer(1 for enable, 2 for
disable)>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<ip_addr> Indicates the IP address of
the Trap Manager to be
added or modified.
Must be unique (the same IP
address cannot be assigned
to more than one Manager)
Mandatory N/A Valid IP
address