User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 428 System Manual
npu# show trap-mgr
4.3.13.2.5 Displaying the Trap Rate Limit
To display the trap rate limit, run the following command:
npu# show trap-rate-limit
IMPORTANT
An error may occur if no Trap Manager has been configured.
Command
Syntax
npu# show trap-mgr
Privilege
Level
1
Display
Format
Trap Manager Table
--------------------------------
Trap Manager Ip:(10.203.153.149) Port:(162) Community:(public) Control
Register: (Enable)
Command
Modes
Global command mode
Command
Syntax
npu# show trap-rate-limit
Privilege
Level
1
Display
Format
Maximum number of traps sent is 20 traps per second.
Command
Modes
Global command mode