User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 441 System Manual
4.3.14.2.5 Configuring the Clock Mode
The Clock Mode parameter enables defining the functionality of the NPU when
GPS chaining is used. In the current release GPS chaining is not supported and
the clock mode must be set to Master.
To configure the clock mode parameter, run the following command:
npu(config)# set npu ClockMode {Master | Redundant | Slave}
Command
Syntax
npu(config)# set position ([Latitude <xxx.xxx,N/S>] [Longitude
<xxx.xxx,E/W>] [Altitude (-300.0 - 9000.0)])
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
Latitude
<xxx.xxx,N/S>
Indicates the latitude where
the 4Motion shelf is currently
positioned. Configure only if
GPS Type is None.
Optional 000.000.N Use the format,
Ill.mmm.a
(where lll.mmm
is in degrees
and the value
of a is either N
or S)
Longitude
<xxx.xxx,E/W>
Indicates the longitude where
the 4Motion shelf is currently
positioned. Configure only if
GPS Type is None.
Optional 000.000.E Use the format,
Ill.mmm.a
(where ll.mmm
is in degrees
and the value
of a is either E
or W)
Altitude
(-300.0 -
9000.0)])
Indicates the altitude (in
meters) where the 4Motion
shelf is currently positioned.
Configure only if GPS Type is
None.
Optional 0.0 -300.0 to
9000.0
Command
Modes
Global configuration mode