User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 447 System Manual
4.3.14.2.12 Displaying the Number of Satellite Parameters
To display the current satellite parameters, run the following command:
npu# show satellite [{MinNumOfSatForHoldoverReturn |
MaxNumOfSatBeforeSyncLoss | NumOfSatelliteAvailable}]
In addition to the configurable parameters, the current number of satellites
acquired by the GPS receiver is also displayed.
4.3.14.3 Managing Power Feeders Configuration
The Power Feeder configuration enables specifying the AU port connected to each
Power Feeder port.
Syntax
Description
For a detailed description of the parameter in this command, refer the section,
“Configuring the
Clock Mode” on page 441
.
Display
Format
NPU Clock Mode : Master
Command
Modes
Global command mode
Command
Syntax
npu# show satellite [{MinNumOfSatForHoldoverReturn |
MaxNumOfSatBeforeSyncLoss | NumOfSatelliteAvailable}]
Privilege
Level
1
Syntax
Description
For a detailed description of each parameter in this command, refer the section,
“Configuring
the Required Number of Satellites” on page 442
.
Display
Format
Max Satellites Before Sync Loss :
Min Satellites For Holdover Return :
Number of Satellites Acquired :
Command
Modes
Global command mode