User Manual

Chapter 4 - Operation and Administration Using the CLI Managing MS in ASN-GW
4Motion 463 System Manual
4.4 Managing MS in ASN-GW
This section describes the MS level commands.
 “Manual MS De-registration”
 “Displaying MS Information”
4.4.1 Manual MS De-registration
Run the following command to initiate the de-registration process of the MS with
the specified NAI value or of all MSs.
npu(config)# de-reg ms {nai <nai-string> | all}
IMPORTANT
An error may occur if NAI value is not specified. Refer to the syntax description
for more information about the appropriate values and format for configuring
this parameter.
An error may occur also for “MS not found", in case no MS with the specified NAI
is registered at ASNGW.
Command
Syntax
npu(config)# de-reg ms {nai <nai-string> | all}
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
de-reg ms {nai
<nai-string> |
all}
Initiates the de-registration of
the MS with the specified NAI
value.If “all” is specified then,
deregister all the MSs.
Mandatory N/A String
Command
Modes
Global configuration mode