User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 138 System Manual
This section describes the commands for:
 “Configuring the IP Connectivity Mode” on page 138
 “Displaying the IP connectivity Mode” on page 139
4.3.1.1 Configuring the IP Connectivity Mode
To configure the IP connectivity mode, run the following command:
npu(config)# connectivity mode {inband | outband | unified}
In-band is the default connectivity mode. You can display the currently configured
connectivity mode. For details, refer Section 4.3.1.2.
Unified
 DATA port
 Bearer VLAN
 DATA port
 Bearer VLAN
 CSCD and MGMT
ports
 Local-management
VLAN
IMPORTANT
Reset the system for the change in connectivity mode to take effect.
Command
Syntax
npu(config)# connectivity mode {inband | outband | unified}
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
{inband |
outband |
unified}
Indicates the connectivity
mode to be configured.
Mandatory inband
 inband
 outband
 unified
Table 4-8: Ethernet and VLAN-to-Connectivity Mode Configuration
Connectivity
Mode
Bearer IP Domain External-Management
IP Domain
Local-management IP
Domain