User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 139 System Manual
4.3.1.2 Displaying the IP connectivity Mode
To display the IP connectivity mode, run the following command:
npu# show connectivity mode
4.3.2 Configuring Physical and IP Interfaces
The following Ethernet interfaces are provided on the front panel of the NPU for
enabling connectivity with external entities:
 DATA port: A Gigabit Ethernet interface that connects the NPU with the
operator network.
 CSCD port: A Gigabit Ethernet interface that provides a dedicated Ethernet
connectivity to the local management NMS Server, or supports concatenation
of two or more 4Motion chassis. (Concatenation is not supported in the
current release.)
 MGMT port: A Fast Ethernet interface that provides a dedicated Ethernet
interface for external EMS server connectivity. In some configurations the
MGMT port is used for connecting the local NMS server (IP-based craft
terminal).
You can configure the speed, duplex, and MTU for these interfaces.
Command
Modes
Global configuration mode
Command
Syntax
npu# show connectivity mode
Privilege
Level
1
Display
Format
connectivity mode is <value>
Command
Modes
Global command mode