User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 142 System Manual
member of one or more VLANs. The following table lists the physical interfaces,
and their type, port numbers and member VLANs:
1 Enable the interface configuration mode (refer Section 4.3.2.3.1).
2 You can now enable any of the following tasks:
» Modify the physical properties of an interface (refer Section 4.3.2.1.2).
» Manage VLAN translation (refer Section 4.3.2.1.3).
3 Terminate the interface configuration mode (refer Section 4.3.2.3.7).
You can, at any time, display VLAN membership information (refer
Section 4.3.2.1.5), and VLAN translation entries for the DATA port (refer
Section 4.3.2.1.7).
4.3.2.1.1 Enabling the Interface configuration mode
To configure a physical interface, run the following command to enable the
interface configuration mode.
Table 4-11: Ethernet Interfaces - Types, Port Numbers, and Member VLANs
Interface Type Physical Interfaces Port
Number
Member VLANs
Fast Ethernet Seven Fast Ethernet
interfaces towards the AU
(internal to the NPU)
0/1-0/7
 Bearer
 Internal-management
MGMT 0/8
 Local-management (in
the in-band or
out-of-band connectivity
modes)
 External-management
(only in the out-of-band
connectivity mode)
Gigabit Ethernet CSCD 0/9
 Local-management
DATA 0/10
 Bearer·
 External-management
(only in-band
connectivity mode)
 Multiple Service VLAN
To configure a physical interface: