User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 158 System Manual
4.3.2.2.2 Displaying the Ether Type
Run the following command to display the current Ether Type value:
npu# show npuetherType
4.3.2.3 Configuring IP interfaces
The following IP interfaces are pre-configured in the system:
 Local-management
 Internal-management
 External-management
 Bearer
1 Enable the interface configuration mode (refer Section 4.3.2.3.1).
2 Shut down the IP interface (if you are modifying configuration information for
this interface) (refer to Section 4.3.2.3.2).
Command
Syntax
npu# show npuetherType
Privilege
Level
1
Display
Format
Ethertype: <value>
Command
Modes
Global command mode
IMPORTANT
You cannot modify the IP address and VLAN identifier for the internal-management interface. You
also cannot modify the VLAN identifier for the local-management.
To configure an IP interface: