User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 163 System Manual
4.3.2.3.5 Configuring/Modifying the VLAN ID for an IP Interface
Run the following command to modify the VLAN ID for this interface:
npu(config-if)# if_vlan <vlanid(9 | 11-100 | 110-4094)>
IMPORTANT
You can modify the VLAN ID for only the bearer, local-management and external-management
interfaces.
NOTE
Refer Table 4-10 for the default VLAN IDs assigned to the bearer, local-management and
external-management interfaces.
IMPORTANT
An error may occur if:
 The VLAN ID you have specified is not within the specified, or is in use by another VLAN. Refer
the syntax description for the VLAN ID range.
 The VLAN ID is already used as a translated VLAN or a VLAN translation entry already exists
for this VLAN.
 You are trying to run this command for the internal-management interface. You can modify the
VLAN ID for only the external-management, local-management or bearer interfaces.
Command
Syntax
npu(config-if)# if_vlan <vlanid(9 | 11-100 | 110-4094)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<vlanid(9 |
11-100 |
110-4094)
Indicates the VLAN ID to be
assigned to this interface.
Note: The VLAN IDs, 1-8, 10,
101-109 are reserved.
Mandatory N/A
 9
 11-100
 110-4094