User Manual
Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 192 System Manual
npu(config-ratelmt)# no rate-limit {ftp | telnet | tftp | ssh |
icmp | snmp | R4-R6 | igmp | <user-defined-app>}
IMPORTANT
While disabling rate limiting for user-defined applications, remember that:
Rate limiting configuration specified for applications categorized as ‘all-others’ is applicable for
all pre-defined/user-defined applications for which you have disabled rate limiting. (However, if
you disable rate-limiting for the entire system, it is disabled completely across pre-defined,
user-defined, and all other applications. For details, refer to Section 4.3.6.2.5.)
After rate limiting is disabled for an application, the application traffic is identical to that of other
applications (applications other than pre-defined and user defined applications.)
You cannot disable rate limiting for EAP and ARP.
An error may occur if you try disabling rate limiting for an application when this feature is already
disabled for the entire system. For details, refer to
Section 4.3.6.2.5.
Command
Syntax
npu(config-ratelmt)# no rate-limit
{ftp | telnet | tftp | ssh | icmp |
snmp | R4-R6 | igmp | <user-defined-app>}
Privilege
Level
10