User's Manual
Table Of Contents
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - Products Description
- 1.1 BreezeMAX CPEs
- 1.2 Introducing BreezeMAX PRO-S CPE
- 1.3 Introducing BreezeMAX Si CPE
- 1.4 Voice and Networking Gateways
- 1.5 PRO-S CPE Specifications
- 1.6 Si CPE Specifications
- Chapter 2 - Installation
- 2.1 Installing the ODU of the PRO-S CPE
- 2.2 Installing the IDU-1D Indoor Unit of the PRO-S CPE
- 2.3 Installing the Si CPE
- 2.4 Installing the 3.5 GHz Detached Antenna
- 2.5 Installing the 2.3/2.5 GHz Detached Antenna
- Chapter 3 - Commissioning
- Chapter 4 - Operation
- 4.1 The SU Installer Monitor Program
- 4.2 Using the Monitor Program
- 4.3 The Main Menu
- 4.4 Unit Control Menu
- 4.5 Registration Parameters Menu
- 4.6 BST/AU ID Parameters Menu
- 4.7 ˘Radio Parameters Menu
- 4.8 Multirate and ATPC Parameters Menu
- 4.9 Performance Monitoring Menu
- 4.10 FDD Parameters (3.x GHz units only)
- 4.11 ˘SU Parameters Summary
- Appendix A - The Web Configuration Server
- Appendix B - Troubleshooting
- Glossary
SU Parameters Summary
BreezeMAX CPEs Product Manual 113
Preferred BST/AU ID 6 groups of up to 3 digits each.
Each group range is 0-255.
186.190.0.0.250.206 No
Preferred BST/AU ID Mask 6 groups of up to 3 digits each.
Each group range is 0-255.
0.0.0.0.0.0 No
Radio Parameters
Bandwidth
1.75 MHz
3.5 MHz
5 MHz
Actually available options
depend on HW
3.5 MHz No
Antenna Selection(Si CPE)
0 (External)
1 - 6 (Internal)
7 (Automatic
Automatic Yes
Scanning Start Frequency Depend on Radio Band and
Bandwidth
Yes
(after Update
Scanning Table
Scanning End Frequency Depend on Radio Band and
Bandwidth
Yes
(after Update
Scanning Table
Scanning Main Step Depend on Radio Band and
Bandwidth
875 KHz Yes
(after Update
Scanning Table
Scanning Intermediate Steps 1
-8
Disable/Enable for each of the
8 Intermediate Steps
Enable for all Steps Yes
(after Update
Scanning Table
Discrete Frequencies Up to 10. Available frequencies
depend on Radio Band and
Bandwidth.
Null (empty list) Yes
(after Update
Scanning Table
Rx Attenuator
(2.3 GHz units)
0, 10 (dB) 0
Multirate and ATPC Parameters
Set Tx Power -26 dBm to the highest value
supported by the unit.
Last power used by
ATPC
Yes
Table 4-2: SU Parameters Summary
Parameter Range Default Run-Time
Updated