User's Manual

Chapter 5 - Configuration Via Web Interface Spectrum Analyzer
Alvarion BreezeNET B130/B300 GigE 90 Technical User Manual
 Band - bandwidth in MHz.
 Step - scanning frequency step in MHz.
 Channel mask - specifies which antenna will scan the radio environment.
"Auto" value set scanning by both antennas.
 Scan Duration - time period for scanning in seconds. After the end of this time
period scanning will be stopped and radio interface will be back to normal
mode operation
 Enable Grid - draws grid lines and highlights the special frequency channel on
the scan output. Special highlighted frequency channel can be used to mark a
channel that the device is currently working on or that is planned for using
 Grid Width -bandwidth value for the highlighted frequency channel in MHz
 Grid Frequency - central operating frequency for the highlighted frequency
channel
 Gradient Max RSSI - shows gradient-color marked "Max RSSI" values on the
Spectrum Analyzer output screen.
To start/stop "Spectrum Analyzer" use "Start Sensor Test"/"Stop Sensor Test"
buttons.
"Last Snapshot" button outputs the final scanning results. It is used when doing a
spectrum scan at the remote unit on the other side of the radio link. When
CAUTION
40MHz band value is not available.
NOTE
It is recommended to set 1 MHz "step" value to get more precise scanning results.
CAUTION
40MHz step value is not available.