User's Manual
Table Of Contents
- BreezeNET B130/B300 GigE Technical User Manual
- Chapter 1 - Getting Started
- Chapter 2 - Hardware Description
- 2.1 Power supply units (IDU)
- 2.2 Outdoor Units (ODU)
- 2.3 Installation Preparations
- 2.3.1 Required Components and Accessories
- 2.3.2 Antenna Placement
- 2.3.3 Antenna Poles Usage
- 2.3.4 Poles with Stretching
- 2.3.5 Wall Mounted Pole
- 2.3.6 Antenna Poles Requirements
- 2.3.7 Grounding when Using IDU-BS-G
- 2.3.8 Antenna Alignment
- 2.3.9 Precaution Measures
- 2.3.10 Service Cable Soldering Procedure
- 2.3.11 Tools Required at the Installation Site
- 2.4 BU/RB-B130D/B300D-5X-GigE
- 2.5 BU/RB-B130/B300-5X-GigE
- 2.6 Mounting Kit (MOUNT-KIT-85)
- 2.7 Specifications
- Chapter 3 - Basic Configuration Instructions
- Chapter 4 - Link Configuration
- Chapter 5 - Configuration Via Web Interface
- Chapter 6 - Supplementary Information
Chapter 3 - Basic Configuration Instructions Lost Password Recovery
Alvarion BreezeNET B130/B300 GigE 43 Technical User Manual
8 Restart the device.
After device restart the ERConsole utility will reset device configuration.
9 Login the device with Serial number as a login name and new password that
was received from tech support.
10 Reconfigure device username and password.
The ERConsole utility's "New task" window also allows setting the unit's
IP-address on its Ethernet interface (eth0) without login to device. To perform this
procedure, follow the steps below:
1 Firstly, do steps 1-3 as described above.
Figure 3-3: ERConsole (Step 3)
CAUTION
The ERConsole reports as "complete" also a failed action because it does not have a mechanism to
verify if the unit accepted the password or not.
CAUTION
Password must be inserted without spaces in order to be accepted by the device.
CAUTION
The "config clear" command followed by a reboot must be performed in order to make available the
radio interface and start unit configuration from default settings.