User's Manual
Table Of Contents
- BreezeNET B130/B300 GigE Technical User Manual
- Chapter 1 - Getting Started
- Chapter 2 - Hardware Description
- 2.1 Power supply units (IDU)
- 2.2 Outdoor Units (ODU)
- 2.3 Installation Preparations
- 2.3.1 Required Components and Accessories
- 2.3.2 Antenna Placement
- 2.3.3 Antenna Poles Usage
- 2.3.4 Poles with Stretching
- 2.3.5 Wall Mounted Pole
- 2.3.6 Antenna Poles Requirements
- 2.3.7 Grounding when Using IDU-BS-G
- 2.3.8 Antenna Alignment
- 2.3.9 Precaution Measures
- 2.3.10 Service Cable Soldering Procedure
- 2.3.11 Tools Required at the Installation Site
- 2.4 BU/RB-B130D/B300D-5X-GigE
- 2.5 BU/RB-B130/B300-5X-GigE
- 2.6 Mounting Kit (MOUNT-KIT-85)
- 2.7 Specifications
- Chapter 3 - Basic Configuration Instructions
- Chapter 4 - Link Configuration
- Chapter 5 - Configuration Via Web Interface
- Chapter 6 - Supplementary Information
Chapter 5 - Configuration Via Web Interface Basic Settings
Alvarion BreezeNET B130/B300 GigE 72 Technical User Manual
5.3.2 Radio Settings
This section allows viewing/setting the following radio parameters:
Interface -available radio interface
Type - network type of the node (Master, Slave)
Channel Width - operating channel bandwidth of the radio in MHz. Must be
equal at both sides of the link
DFS - allows starting DFS (Dynamic Frequency Selection) service or DFS
without Radar Detection
Frequency - central operating frequency in MHz. Must be equal at both sides
of the link.
Frequency range list - list of frequencies allowed for choosing by DFS service
TX Power - output power of the radio in dBm. "Auto" field enables ATPC
function (recommended)
Tx Bitrate - fixed operating bitrate (if numerical value chosen) or auto bitrate
(Automatic Modulation Control) if "Auto" is chosen. "Autobitrate" is
recommended
Figure 5-3: