User's Manual
Table Of Contents
- BreezeNET B130/B300 GigE Technical User Manual
- Chapter 1 - Getting Started
- Chapter 2 - Hardware Description
- 2.1 Power supply units (IDU)
- 2.2 Outdoor Units (ODU)
- 2.3 Installation Preparations
- 2.3.1 Required Components and Accessories
- 2.3.2 Antenna Placement
- 2.3.3 Antenna Poles Usage
- 2.3.4 Poles with Stretching
- 2.3.5 Wall Mounted Pole
- 2.3.6 Antenna Poles Requirements
- 2.3.7 Grounding when Using IDU-BS-G
- 2.3.8 Antenna Alignment
- 2.3.9 Precaution Measures
- 2.3.10 Service Cable Soldering Procedure
- 2.3.11 Tools Required at the Installation Site
- 2.4 BU/RB-B130D/B300D-5X-GigE
- 2.5 BU/RB-B130/B300-5X-GigE
- 2.6 Mounting Kit (MOUNT-KIT-85)
- 2.7 Specifications
- Chapter 3 - Basic Configuration Instructions
- Chapter 4 - Link Configuration
- Chapter 5 - Configuration Via Web Interface
- Chapter 6 - Supplementary Information
Chapter 5 - Configuration Via Web Interface Basic Settings
Alvarion BreezeNET B130/B300 GigE 74 Technical User Manual
5.3.4 Link Settings
This section allows viewing/setting the following link parameters:
Interface - available radio interface
Network SID - Network System Identifier (8-digit HEX figure). All units that are
supposed to see each other on the same radio link must have the same SID
value
Node Name - the network name for the node
Node ID - the sequential number for the node. The parameter is optional
Security Key - key word to encode protocol messages. The key can be up to 64
characters long and should not contain spaces (or should be put in quotes). All
units that are supposed to see each other on the same radio link must have
the same Security Key
Encryption - enables hardware-accelerated AES-128 encryption for all the
traffic
Marker Access - turns marker access (Polling) mode on. This mode is
recommended for long PTP links (7+ km). Should be enabled just at one side of
the PTP link (do not enable polling at both sides, otherwise wireless connection
will fail!)
Figure 5-5: Link Settings