User's Manual
Table Of Contents
- 1 Introduction
- 2 The Concept
- 3 BreezeCELL Architecture
- 4 BreezeCELL Network Elements
- 5 Frequency Allocations
- 6 MIMO Support
- 7 Monitoring & Control
- 8 Installation Requirements and Procedures
- 9 Headend Equipment Installation
- 9.1 Connector Information
- 9.2 Rack Installation
- 9.3 Connecting the BreezeCELL Equipment
- 9.4 Connecting the Monitoring System
- 9.5 Connecting External Alarms
- 9.6 Connecting the Base Stations
- 9.7 UDC Configuration
- 9.8 Pilot Master/Slave Configuration
- 9.9 Measurements
- 9.10 Connecting to the Coax TV Networks
- 9.11 Measurements
- 9.12 Localized Testing Port
- 9.13 Determining BTS Output Power VS. Remote Unit Output Power
- 10 Coax Network Amplifier Installation (if applicable)
- 11 Remote Unit Installation
- 12 Preparing for Remote Unit Installation
- 13 Normal Operations
- 14 Acceptance Testing
In-building Cellular Solution for Commercial Buildings UDC Software Configuration Tool
BreezeCELL
9
Additional two pole disconnect device (disconnect all poles simultaneously) should be provided in
the building installation
Monitoring system comprise of a Pizza box rack mounted PC. In case remote access is required, a
TCP/IP link should be available as well.
It is advisable that the BreezeCELL equipment will be co-located with the cellular BTS/Repeater and
the TV headend. Otherwise connecting cables should be prepared.
Equipment should be used in a RESTRICTED ACCESS LOCATION only
8.3 Coax Plant (if applicable)
Available power outlet next to each TV amplifier
Socket outlets should be installed near the equipment and shall be easily accessible
Additional two pole disconnect device (disconnect all poles simultaneously) should be provided in
the building installation
Available space for 2 diplexers and 1 amplifier next to each TV amplifier
Equipment should be used in a RESTRICTED ACCESS LOCATION only
8.4 Rooms (in case of CATV plant)
TV outlet
Available power outlet next to each TV outlet
9 Headend Equipment Installation
9.1 Connector Information
9.1.1 UDC
BTS/Node B: SMA female
10 MHz input: BNC female
Alarm output: D-type, 9 pin
9.1.2 CCD
UDC Up link: SMA female
UDC Down link: SMA female
10 MHz output: BNC female
RF output: F type female