User's Manual
Table Of Contents
- 1 Introduction
- 2 The Concept
- 3 BreezeCELL Architecture
- 4 BreezeCELL Network Elements
- 5 Frequency Allocations
- 6 MIMO Support
- 7 Monitoring & Control
- 8 Installation Requirements and Procedures
- 9 Headend Equipment Installation
- 9.1 Connector Information
- 9.2 Rack Installation
- 9.3 Connecting the BreezeCELL Equipment
- 9.4 Connecting the Monitoring System
- 9.5 Connecting External Alarms
- 9.6 Connecting the Base Stations
- 9.7 UDC Configuration
- 9.8 Pilot Master/Slave Configuration
- 9.9 Measurements
- 9.10 Connecting to the Coax TV Networks
- 9.11 Measurements
- 9.12 Localized Testing Port
- 9.13 Determining BTS Output Power VS. Remote Unit Output Power
- 10 Coax Network Amplifier Installation (if applicable)
- 11 Remote Unit Installation
- 12 Preparing for Remote Unit Installation
- 13 Normal Operations
- 14 Acceptance Testing
In-building Cellular Solution for Commercial Buildings UDC Software Configuration Tool
BreezeCELL
20
After logging in, the main screen will be the Alarms Log.
12.2 Configuring a Global Parameter Set (GPS)
A group of remote units with the same frequency requirements should be allocated a common
parameter set called GPS. Each GPS include:
Cellular (Air) Up Link Frequency
Cellular (Air) Down Link Frequency
CATV Up Link Frequency
CATV Down Link Frequency
A change in the GPS will generate a change in each remote unit using this GPS.
Note: You can’t edit the GPS name, as this is used by its associated remote units
12.2.1 Adding a GPS
1. From the menu GPS MAINTENANCE choose Add Group Parameters
2. Press the ADD GPS button on the top left side of the screen. The GPS configuration table will
appear.
3. Enter a Name and Description of the GPS. The name should be unique.
4. Choose the technology from the list: GSM 900, GSM 1800, UMTS, PCS, iDEN, US Cellular
5. Choose the channel Bandwidth of the remote unit (factory hardware preset)
6. Fill in the Cellular and CATV frequencies according to your frequency plan so that there is a match
with the channel bandwidth and the technology. The frequency units are [KHz]
7. Press Save to update the database
8. Repeat steps b to g for each GPS required in the network