User's Manual
Table Of Contents
- 1 Introduction
- 2 The Concept
- 3 BreezeCELL Architecture
- 4 BreezeCELL Network Elements
- 5 Frequency Allocations
- 6 MIMO Support
- 7 Monitoring & Control
- 8 Installation Requirements and Procedures
- 9 Headend Equipment Installation
- 9.1 Connector Information
- 9.2 Rack Installation
- 9.3 Connecting the BreezeCELL Equipment
- 9.4 Connecting the Monitoring System
- 9.5 Connecting External Alarms
- 9.6 Connecting the Base Stations
- 9.7 UDC Configuration
- 9.8 Pilot Master/Slave Configuration
- 9.9 Measurements
- 9.10 Connecting to the Coax TV Networks
- 9.11 Measurements
- 9.12 Localized Testing Port
- 9.13 Determining BTS Output Power VS. Remote Unit Output Power
- 10 Coax Network Amplifier Installation (if applicable)
- 11 Remote Unit Installation
- 12 Preparing for Remote Unit Installation
- 13 Normal Operations
- 14 Acceptance Testing
In-building Cellular Solution for Commercial Buildings UDC Software Configuration Tool
BreezeCELL
21
In the case of a dual technology remote unit, two separate GPSs are required for the remote unit to be
fully operational.
12.2.2 Deleting a GPS
Note: You should delete a GPS only if there are no remote units that belong to this GPS!
1. From the menu GPS MAINTENANCE choose View Group Parameters
2. Press the EDIT button of the relevant GPS
3. Press the DELETE button
4. Press the confirmation button
12.3 Adding and Registering a New Remote Unit
Each remote unit installed in the network should be defined and registered prior to installation.
1. From the remote unit MAINTENANCE menu choose Edit/Add remote unit
2. Press the Add remote unit button on the top left side of the screen. The remote unit configuration
table will appear.
3. Input all remote unit parameters:
Remote unit ID = serial number
Location [Free text]
Information [Free text]