User's Manual
Table Of Contents
- 1 Introduction
- 2 The Concept
- 3 BreezeCELL Architecture
- 4 BreezeCELL Network Elements
- 5 Frequency Allocations
- 6 MIMO Support
- 7 Monitoring & Control
- 8 Installation Requirements and Procedures
- 9 Headend Equipment Installation
- 9.1 Connector Information
- 9.2 Rack Installation
- 9.3 Connecting the BreezeCELL Equipment
- 9.4 Connecting the Monitoring System
- 9.5 Connecting External Alarms
- 9.6 Connecting the Base Stations
- 9.7 UDC Configuration
- 9.8 Pilot Master/Slave Configuration
- 9.9 Measurements
- 9.10 Connecting to the Coax TV Networks
- 9.11 Measurements
- 9.12 Localized Testing Port
- 9.13 Determining BTS Output Power VS. Remote Unit Output Power
- 10 Coax Network Amplifier Installation (if applicable)
- 11 Remote Unit Installation
- 12 Preparing for Remote Unit Installation
- 13 Normal Operations
- 14 Acceptance Testing
In-building Cellular Solution for Commercial Buildings UDC Software Configuration Tool
BreezeCELL
26
Hardware version
Software version
Communication protocol version
Output power type – 0 dBm or 10 dBm
Instances – Single or Dual band
GPS 1 – Global Parameter Set for instance 1
GPS 2 – Global Parameter Set for instance 2
3. On the left side of each remote unit entry there is an INFO button. Pressing the view button will
show the full detail list for the chosen remote unit.
13.3.3 Viewing the Complete Information of a Single Remote Unit
1. From the Operational remote unit screens, press the info button
2. Alternatively, from the remote unit Maintenance menu choose remote unit Information
3. Search for the relevant remote unit according to the remote unit ID/Location/Information
4. The chosen remote unit will be displayed with complete information
5. The remote unit info can be refreshed by pressing the GET STATUS button
6. The remote unit can be controlled by pressing the SEND CONTROL button. This action will link to
the remote units commands page with the chosen remote unit
The following information is available for each remote unit: