User's Manual
Table Of Contents
- 1 Introduction
- 2 The Concept
- 3 BreezeCELL Architecture
- 4 BreezeCELL Network Elements
- 5 Frequency Allocations
- 6 MIMO Support
- 7 Monitoring & Control
- 8 Installation Requirements and Procedures
- 9 Headend Equipment Installation
- 9.1 Connector Information
- 9.2 Rack Installation
- 9.3 Connecting the BreezeCELL Equipment
- 9.4 Connecting the Monitoring System
- 9.5 Connecting External Alarms
- 9.6 Connecting the Base Stations
- 9.7 UDC Configuration
- 9.8 Pilot Master/Slave Configuration
- 9.9 Measurements
- 9.10 Connecting to the Coax TV Networks
- 9.11 Measurements
- 9.12 Localized Testing Port
- 9.13 Determining BTS Output Power VS. Remote Unit Output Power
- 10 Coax Network Amplifier Installation (if applicable)
- 11 Remote Unit Installation
- 12 Preparing for Remote Unit Installation
- 13 Normal Operations
- 14 Acceptance Testing
In-building Cellular Solution for Commercial Buildings UDC Software Configuration Tool
BreezeCELL
29
Instance 2 – Turn instance 2 output RF off
3. Press the SEND button
4. Press the CONFIRMATION button
Note: Global Command may be Service effecting and generate a service down time. Sending a Global
Command will generate a process of communication between all remote units and the Monitoring
system. When performing a Global Command such as RESET, sufficient time should be allowed for all
elements in the system to respond and stabilize. Do not perform any operations for 2 minutes.
Note: Only a single command can be issued!
13.4.3 Editing Remote Unit Configuration
1. From the remote unit Maintenance menu choose Edit/Add remote unit
2. Choose the relevant remote unit from the list
3. Press the EDIT button on the left side of the row
4. An information screen will appear on the right side
5. Modify the required parameters:
Remote unit Location – Free Text
Remote unit Information – Free Text
Number of Instances – Choose the correct option for the remote unit
GPS 1 – Choose the relevant GPS for instance 1
GPS 2 – Choose the relevant GPS for instance 2
6. Press the SAVE button will generate communication to update the remote unit in the field