User's Manual

Appendix A. Radio Signal Propagation
User's Manual A-26 BreezeNET DS.11
4.1.9 Debug Info
This option allows you to create a log file, named BreezeLog.log. Later you can
send this log file to BreezeCOM Technical Support and receive help based on the
information recorded in this file.
To start recording, open the Debug Info option and select Start Log.
When you finish recording (usually after 24 hours) select Stop Log and send the
file to BreezeCOM Technical Support representatives.
4.2 Quick Start to Wireless Networking
Perform the following steps to configure a WLAN for the first time:
1. Physically connect the Access Points to the Ethernet LAN. Make sure they are
switched on. The DS.11 wireless network will be up and running immediately.
If you are content with the default settings of the Access Points, you can stop
right here. It is more likely however, that you want to assign different radio
frequencies to each Access Point, or impose some restrictions on the use of
your wireless network.
2. To be able to manage the Access Points via SNMP, every Access Point needs a
unique IP address. If you provide a DHCP or BOOTP service on your LAN
(and have sufficient free IP addresses available) this will be taken care of
automatically. If not, refer to Section 4.1.2.2 for further information on
assigning IP addresses.
3. Use the BreezeNET Management utility to configure the Network Settings to
reflect your situation.
4. Select the radio channels of the Access Points according to your cell plan. See
Section 4.1.4 for further information. Add descriptive information about each
Access Point for later reference.