User Manual

Device Setup and Management
BreezeNET PRO.11 Series 3-19 User’s Guide
• Power Level – Level of power at which the unit is operating. There are
two possibilities, Low or High. In this case, the unit is operating at a
high power level. Do not make any changes to this setting.
• Number of Packets to Tx – Number of data packets transmitted. Do not
make any changes to this setting.
• Time Between Packets – Time between data packets measured in 100
millisecond units. Do not make any changes to this setting.
• Packet Length – Length of each data packet measured in bytes. Do not
make any changes to this setting.
• Display Rx Packets per Frequency – Histogram of the number of
frames received on each channel. This graph is explained fully in section
3.6.4 Using the Rx Packets per Frequency Histogram.
• Display Actual Configuration – Default parameters to be used in the
Site Survey procedure.
• Load Default Configuration – If any changes were made for any
reason to any of the previous parameters, select this option to cancel
these changes and return to the original default parameters.
• Start Statistics – Press S and then press any digit to start Site Survey.
• Stop Statistics – Press Q and then press any key to stop update of Site
Survey statistics.
3.6.3. Using the Site Survey Software
⇒⇒ To use the Site Survey Software:
1. Roughly align the antennas on either side of the link before starting
the Site Survey procedure.
2. Verify that the Ethernet cables are disconnected from both units.
3. Press 1 to go to the Operation mode screen. Set the units on either
side of the link to either receive (option 1) or transmit (option 2)
packets (one unit should be set to transmit and the other to receive).
Option 0 (Idle mode) is not active at present.
4. Make no changes in the following sub-menus: